Hi i have some questions about this procedure. I have cleaned the collectors 2 times but with no gain. When i check with vag-com it looks like all sensors is fine. They are 11011010 and 10 1010 when the roof is on. When roof is manually folded to trunk they are 00100001 and 10 1010. I think thats right. I have raised the roof manually och it looks like all the bits "toggles" on and off (except that one that is not used, second in 001,3). Then they should be ok?
The roof just "unlatches" from the windshield frame and then stops, after stopping i have to manually lower it, button does not work. After lowering it it works again (but ofcourse stops at the same point). The hydraulic motor shold engage there i think.
G356 goes from 236 to 28, looks like numbers other ppl are having also.
003,0 is all zeroes. ?
004,1 is all zeroes.
006,0 to 007,4 are all not used ?
The varible storage compartment lever and its sensors does not show in vag-com? When i move the lever front and back nothing changes in vag-com. Will the roof start raising (it unlatches) even with that lever in the wrong position? Mine does.
When i use "output tests" the steps that test relay J588 and J321 both seems to run the hydraulic pump/engine. That proves that its not the collectors that is dirty, right? All other steps show "on" in that first square.
I have also tried to connect another car with jumpercables and have that one running and then looked in realtime on the voltage on pin 30. It barely sinks. I tried this because i have some 00532 (and 18010) errors.
Please give me all your ideas because i am pretty stuck.