- Joined
- Nov 24, 2010
- Messages
- 15,084
- Reaction score
- 1,131
- Points
- 113
- Location
- Plymouth
- Website
- wheelsnwires.blogspot.com
First is the clip.
You've all seen them before and I wanted one.
So I bought one and fitted it.
Heres some pictures.
Remove the A pillar trim and your left with this.
Fit clip in the location you like. I used double sided sticky tape. I was going to use a screw but due to the angle and how close it is to the screen, I went with the tape.
and then fit it all back together. Time will tell how long the tape holds. It should last cause the pillar also holds the clip.
Next was the little metal panel on the rear windows.
When I replaced my manual rear windows for electric rear windows I forgot to swap this bit over.
With a spare 5mins I finally got round to it.
The corroded panel, which is also the wrong colour.
Remove the inside plastic panel to expose the torx bolt.
Slide the panel down as far as it can go and then wiggle it till it comes out.
And refit the correct panel and put it all back together.
You've all seen them before and I wanted one.
So I bought one and fitted it.
Heres some pictures.
Remove the A pillar trim and your left with this.
Fit clip in the location you like. I used double sided sticky tape. I was going to use a screw but due to the angle and how close it is to the screen, I went with the tape.
and then fit it all back together. Time will tell how long the tape holds. It should last cause the pillar also holds the clip.
Next was the little metal panel on the rear windows.
When I replaced my manual rear windows for electric rear windows I forgot to swap this bit over.
With a spare 5mins I finally got round to it.
The corroded panel, which is also the wrong colour.
Remove the inside plastic panel to expose the torx bolt.
Slide the panel down as far as it can go and then wiggle it till it comes out.
And refit the correct panel and put it all back together.