Well I started refurbishing my wheels last night; I think it went well, so far so good.
As you can see the wheels are in a bad condition and some marks are quite deep
I attached a sanding drill bit to my drill
And attacked them at full stream!!!
I then just went over the rest of the wheel to create a rough surface
So at weekend I need to wet and dry sand them and hopefully get primer on, (still not sure what colour to do them). It has been easier than expected, or have I missed a trick?? Or is the hard work still to come???
Please offer me your words of wisdom!!!!!!
As you can see the wheels are in a bad condition and some marks are quite deep
I attached a sanding drill bit to my drill
And attacked them at full stream!!!
I then just went over the rest of the wheel to create a rough surface
So at weekend I need to wet and dry sand them and hopefully get primer on, (still not sure what colour to do them). It has been easier than expected, or have I missed a trick?? Or is the hard work still to come???
Please offer me your words of wisdom!!!!!!