Hi everyone, not sure if anyone can help me with an issue i have on a 2008 audi a6
the car had a fire in the boot area
i have replaced the loom and modules in the boot and using vcds cable i have coded in the comfort module
with basic settings
the issues i am having are as follows
the interior lights come on when i first open the car and then go off when ignition is switched on after this they will not come on even the map reading lights glovebox and boot lights
if i lock the car up and try again in say half an hour i get the same effect
also the rear park sensors are not working
fault codes that come up refer to active protection mode being active
any help is appreciated all fuses etc are fine
hello again to all
the car had a fire in the boot area
i have replaced the loom and modules in the boot and using vcds cable i have coded in the comfort module
with basic settings
the issues i am having are as follows
the interior lights come on when i first open the car and then go off when ignition is switched on after this they will not come on even the map reading lights glovebox and boot lights
if i lock the car up and try again in say half an hour i get the same effect
also the rear park sensors are not working
fault codes that come up refer to active protection mode being active
any help is appreciated all fuses etc are fine
hello again to all
