ABS Brakes fault

[DeckedS3]

Hello,
I've just done a scan and as the scan started, up on the dash it said ABS fault, drive to dealer carefully..... I though it was a bit odd so as the scan went on, sure enough it's popped up with an ABS fault.

1 Fault Found:
01314 - Engine Control Module
004 - No Signal/Communication - Intermittent
Freeze Frame:
Fault Status: 00100100
Fault Priority: 2
Fault Frequency: 2
Reset counter: 156
Mileage: 2700 km
Time Indication: 0
Date: 2008.12.29
Time: 14:10:53
Freeze Frame:
Count: 0
Count: 0
Count: 12800
Count: 8194
Count: 43264
Count: 0
Count: 0
Count: 0

I took the car out and tested the ABS and it's working fine..... So I cleared the code.
I then did another scan and straight away it popped up on the dash ABS fault, drive to dealer carefully but this time no fault code.......
Is it normal for this to pop up when doing a scan? I have run the scan a few times now and the same thing happens but no code.
The ABS fault was some time ago so it wasn't recent....... Bit weird if you ask me.
Can anyone shed some light on this?
Thanks

EDIT: There was also this......

Cent. Elect
1 Fault Found:
01314 - Engine Control Module
004 - No Signal/Communication - Intermittent
Freeze Frame:
Fault Status: 00100100
Fault Priority: 6
Fault Frequency: 2
Reset counter: 156
Mileage: 2700 km
Time Indication: 0
Date: 2008.12.29
Time: 14:10:00
Freeze Frame:
ON
Voltage: 11.90 V
OFF
ON
OFF
OFF
OFF

CAN Gateway
1 Fault Found:
01314 - Engine Control Module
004 - No Signal/Communication - Intermittent
Freeze Frame:
Fault Status: 00100100
Fault Priority: 2
Fault Frequency: 2
Reset counter: 156
Mileage: 2700 km
Time Indication: 0
Date: 2008.12.29
Time: 14:10:54

 

[thorsy22]

When scanning I believe it turns the ABS controller off so you get the error. Not sure if it logs a fault code though.
Though may be wrong