8P Wirper coding "Tear Wiping active"

[dantdi]

HI i Emailed ross-tech about activing the tear wipe. Like what my old a3 use to do.
They sent me this back.

Hello Dan,

The instructions you found are correct. The wiper motor is a
slave
(sub-system) module from address 09:

[Select]
[09-Central
Electronics]
[Coding]
Choose the Component: Wischer AU350 H01 0130 from
the drop-down
[Long Coding Helper]
Tick "Tear Wiping active" and exit the
helper
[Do It!]


I get to choosing Wischer AU350 H01 0130 from the drop-down
then click on coding helper (long Coding helper not there)
Then just get load black boxes from bit1 to bit 20 nothing about "Tear Wiping active" ??

anyone help me out here, I'm a complete noob! with vag-com and poo myself every time i click button
Just incase mess something up.

Thanks
The Dan

[Sandra]

Maybe try drop user NHN a pm. He should be able to advise.

[dantdi]

Thanks, Yeah may have to bug Mr NHN

[NHN]

Show us a screen shot of the issues in coding.

[dantdi]

Ok Will do!

[dantdi]

This is what i get when iChoose the Component: Wischer AU350 H01 0130 from
the drop-down (Only Coding Helper) not Long Coding Helper



When i click on coding helper.

[NHN]

Did you press tab within the long coding window to check if byte 01 & 02 had any descriptive tick boxes given they have hex code in them.

Also update to vcds 11.11 now as its released.

[dantdi]

No, didn't click on tabs in long coding window. Have to check them tomorrow now. It's bloody rainning at mo.
I will Post what i find in other tabs with screen shots.

Yep when turned Laptop on got the 11.11 update Thanks Nigel

[NHN]

Rain doesnt stop anyone, close the door, job done, go on get on with it :P

[dantdi]

! Sorry mate. Google my laptop (hp dragon laptop) and see why i can't do that, Break my bloody legs!

Needs one these little netbooks for Vag-com me thinks!

[NHN]

It has a handle on the rear, use it :P

[dantdi]

Ok, i've checked the tabs
When i click on tab LCode2 from this window


I get this


Click ok then this window opens

Bit0 to bit7 dosn't tell me anythink when the Cursors is over then.

[dantdi]

If i dont Choose the Component: Wischer AU350 H01 0130 from
the drop-down menu.


There is the LONG coding helper

[NHN]

No man, I mean, put the cursor into the 1st box that shows 00, then press tab to go along to the box that shows F5, then press tab again so it goes to the next box that shows 10, these are the bytes I'm referring to, hence byte 00 is 1st box, byte 01 is 2nd box & so on, it says byte 0, byte 1 etc underneath the box.

[dantdi]

Ohhhh!! i seee! Bugger!!
Right ok.

[dantdi]

Sorry late reply internet been down (talktalk)

Nigel your a star mate!! Was under F5 as u said. Just taken it out for drive to try it and it Works!

Thanks again Nigel

[NHN]

Great