first Time user checking torsion value

[nokia_aid]

ok just used my ross tech cable for the first time today,my car has an overfueling issue when its cold that im trying to find the cause,

checking my torsion value first. and when i first start the car its at about 11 then drops down to 2.5 is that normal or should it start lower

below is a link to a log i took

LOG-01-004-xxx-xxx.CSV - File Shared from Box.net - Free Online File Storage



only error code i had was

16685 - Cylinder 1: Misfire Detected
P0301 - 000 - -
Freeze Frame:
RPM: 819 /min
Torque: 100.0 Nm
Speed: 0.0 km/h
Load: 0.0 %
Voltage: 14.21 V
Inj. Quantity: 2.96 mg/str
Temperature: 13.5°C
(no units): 0.0

 

[ZeeSaffa]

Hi,
Did you manage to correct your torsion value?
I have a bit of a judder at certain revs and have just found out (thanks to the help of a fellow ASN member's VCDS) that my torsion value is 3.9 (advanced).
So, I'm going to have to do fine tune the camshaft timing as described here:

How to adjust rough idle and camshaft timing on VW and Audi TDI pumpe duse engine

I'm interested to know if you went through the same thing and if you have any advice?

Thanks!