Front Parking Sensor
My front passenger side parking sensor on my Audi B7 S4 has receeded into the bumper by about 10mm any clues how to get it out without taking the bumper off?
After a drive in some very wet and miserable conditions my ESp light and EPC light came on the engine went into limp mode briefly. so I got the old cable out and plugged it in. the car had been fine up until this point.
Address 01: Engine Labels: 079-910-560-BBK.lbl Part No SW: 8E3 910 560 HW: 4E0 907 560 Component: 4.2L V8/5V G 0020
Revision: --H01--- Serial number:
3 Faults Found:
16684 - Random/Multiple Cylinder Misfire Detected P0300 - 001 - - Intermittent
16691 - Cylinder 7 P0307 - 001 - Misfire Detected - Intermittent
18047 - Accelerator Position Sensor 1/2 (G79/G185) P1639 - 008 - Implausible Signal
Readiness: 0000 0000
I've cleared the faults but havent had a chance to drive it yet. I was wondering if this could have been caused by the ECU getting water in it or am I just being hopeful (it was an horrendous day)
VAG Com remote tweaks.
I have an S4 B7 cab and have tried the windows down with remote tweak but can't get it to work the widows roll a 1/4 of the way down and stop but then go no further and also won't go up with the remote either.
has anybody successfully managed this and if so share your genius ways.