- Audi S3 (BAM)
- Dolphin Grey
2002 Dolphin grey S3 - Sym2+bose, heated leather, ally mirrors, R32 ARB's with superpro, Jabba stage 2 map, TFSI coils, Samco TIP, Forge DV & privacy glass
2010 Green Kawasaki Ninja ZX6R - Akrapovic baffleless race can, LED cluster & HID's
wanted for 8L S3:
Unmarked grey rear bumper panel
- Leaderboard Rank
- Not ranked
- Games Started
- Games Finished
- Time Spent Playing
- 0 hours, 0 minutes, 0 seconds
0 - 0 Wins / 0 Losses, 0 Initiated
- Challenge mattyboy199
sab_07 liked post by mattyboy199 On thread : Does anyone know the purpose of this ?
I was cleaning the S3 today & there was a load crap sitting on top of the strip which was lose anyway so i've removed it. Its metal encased in rubber & not connected to anything. Held on by a 3M foam...
Liked On: 19th January 2014, 18:24
mark_S3 liked post by mattyboy199 On thread : Audi S3 8L Brake Disc and Pads Replacement Guide
prepared to drill out the little cross head screw that holds the old disc on
All you need here is an oversized philips headed screw drivers & a mallet to bang it in, this should allow you undo...
Liked On: 1st December 2013, 21:27
Pubemammal liked post by mattyboy199 On thread : Rotational knock
I bet its the power steering pipe on the drive shaft !
Liked On: 22nd November 2013, 01:30
hopey88 liked post by mattyboy199 On thread : few little issuse
just for the record my post cat o2 lambda sensor was playing up, i soaked it in vinegar for about a week reinstalled it & it hasnt thrown up a fault since (this was about 3-4months ago).
Liked On: 3rd August 2013, 01:25
voorhees liked post by mattyboy199 On thread : Bye Bye S3
mk5 Edition 30 Golfs make 300BHP on a stage 1 remap......no brainer
Liked On: 29th May 2013, 22:17
Dani_B19 liked post by mattyboy199 On thread : How to Remove Aerial Base?
There are two types of aerial bases, the 1st has the nut inside & the amplifer is built into the cone shape which sits on the roof. the 2nd has the nut outside & the amplifer shaped as a metal box...
Liked On: 16th May 2013, 14:04
BenJee_S3 liked post by mattyboy199 On thread : S3 Bam post cat lambda sensor (S2) help
Already had mine out, the heat shield isnt in the way, you cant miss it tbh. I would suggest spraying it up 24hrs before with wd40. I just used a spanner & hammer which eventually freed it up. Still...
Liked On: 8th April 2013, 23:07
Westy liked post by mattyboy199 On thread : Standard spring differences (rears)
I recently replaced my rear springs & after digging around on the net i learnt that 3 silver dot springs should allow my car to sit lower in place of my 5 pink dot rears although they had cracked it...
Liked On: 10th March 2013, 18:52
ice_cube99 liked post by mattyboy199 On thread : New S3 on Top Gear
They rarely do an RS model, the TTRS or RS3 didnt get a look in.
Liked On: 6th November 2012, 13:54