Light problems after attempting Coming home light hack...Please help
Hi, I know theres a fair few threads on here about coming home lights showing what needs to be done and what problems people have had but I dont seem to be able to find mine on there.
Basically this is what happened. I have my neighbours laptop with full VCDS on it so I thought as I have it until Sunday Id do this little upgrad as it sounds like a usefull feature.
Anyway I followed the guide and usind a repair wire I connected one endt to pin 12 in block E and the other end I earthed to the bolt as shown in the guide. I had it conected to the block and then secured the earth point before reconnecting block E.
I then activted the coming home feature through VCDS via module 09, central electrics and checked bit 5 and 7 and saved the changed with the "Done, Do it" button.
I got out of the car and locked it, the lights stayed on for 30 seconds then went off and the same goes for unlocking. Perfect I thought...
However when I have the light switch in DRL mode I have the dipped headlights on, when I put the lights to dipped I have only DRL but all the amnient lighting comes on in the car as well as the dash lights and main beam is as it used to be, so basically the dipped and DRL seemto have been switched around somehow.
I thought Id remove the cable from pin 12 so I removed it from the earthing point and covered the end with electrical tape whilst I look into things. I used VCDS and unchecked the boxes and saved it again so its all back to as it was before I began.
Now the coming home feature is still active as it was and the light switch is still all mixed up as in the DRL and dipped settings are switched?
How is this possible? Ive put everything back as it was, ideally Id like to have the coming home feature but more so than that Id ike to have a light switch that works properly!
Any help is greatly appreciated.
I forgot to add that I have already got the advanced comfort setting active through chanel 17 bit 82...