8L S3 RNS-E Retrofit help please
i am attempting to retro fit RNS-E form an A4 into my 02 8L S3 which currenly has a symphony 6cd double din headunit and the bose speaker package..
I have read alot of guides some on here and a few PDF`s and i think i have done everything i need to but am still having issues.
So this is what i have done so far (did all this without cutting up the RNS-E to make it fit to make sure i could get it to work)
I have removed the dash clocks and connected a wire to the blue connector pin 31 (green and white wire) and run this to the rnse v-sig. I have also run 2 wires from the grey connector to the can high and can low on the rnse.
I have then coded the unit using VCDS to make it an A6 with Bose 0509111
and then set the adaption channels :
8 to 255
2 to 08
and 001 to 1943
i have then reset the RNS-E by holding the radio and setup buttons unitl the screen blanks.
The 2 problems i get is:
1) the sat nav does not move when i drive the car. It picks up where i am to start with and displays on the DIS etc but as i move the car down the road the blue pointer stays at the original location and i dont get any sat nav instructions. (I know the RNS-E works as i tested it in my dads a4 when it first arrived)
2)When i turn the unit on i get a buzz from the passenger speaker all the time which gets worse when i start the engine. It did not buzz like this when the original headunit is fitted to the car.
Any help would be greatly appreciated