Soft Coding to enable DIS
Hi guys, I'm after a bit of help regarding the retrofit of a dis cluster.
its all installed, used vag tacho and vcds and alls well, had it in for a month. However, I've now installed a wiper stalk with rocker switch etc, with new repair wires connecting into the cluster as necessary, but the stalk doesn't activate the dis. I've tried a new stalk, and checked all the wires, was just wondering if there is a coding I need to change to enable the stalk and DIS?
its a non can bus, full dis, with the orange warning symbols at the top, (I have a bulb out in the 3rd brake light) the middle section is blank but will have the outside temp once connected, and the bottom has miles to empty I think, although the miles only goes to 100 with a full tank, so out by a factor of 5 I think.
If anyone can help in enabling this dis I'd be most appreciative, spent loads of time and effort in getting it installed, and falling at the last hurdle!