Right, previous to my thread a hile ago now about getting the car done i finally gave it a good going over. The detail was done back in November but have been quite busy since. Its by no means perfect but im more than happy with the way things came out.
I wont bore you too much with all the products but they include:
paint: hyperwash, megs quick clay kit, g220 hard paint kit with blackfire paint sealant x2 layers,
Alloys and whels:wheelbrightner, jeffs prime for the alloys, blackfire tyre gel and poorboys wheel sealant
Metals: megs nxt metal cleaner with blackfire metal sealant.
Car started like this:
Usual road grime and dirt.
So wheels power rinsed first then sprayed with WB and aggitated with ez detail brush and my trusted little halfords brush
All then rinsed through thoroughly leaving something like this:
Same completed for all four wheels.
Car then rinsed at high pressure before foaming with megs hyperwash. Foamed leaving this
Left to dwell for 10mins and then rinsed leaving:
Each panel then washed with hyperwash along with 2BM. One panel at a time starting from top to bottom.
And so on. All then power rinsed off to leave..
Looking alot better if i do say so!
Then onto the claying:
to this after just the bonnet!!
Car then washed again with 2BM and dried.
I then started slowly as this was the first time with machine polishing. Car taped up section by section and let the polishing begin.
The next lot is a blur and spread over two days but basically went through the whole car with correction and the polishing. Not the best before and after pics but i think you get the point.
Nice reflecion shot after correction: