I am testing the water here to see if it would be worth selling my ECU with Stage 3 map from Revo on it.
The map is to suit an Audi A4 or VW Passat 1.8T with the following modifications.
GTRS turbo setup
decat or highflow cat
Stock MAF housing with stock sensor
Highflow turbo intake
FMIC capable of supporting 450bhp (stock IC is not efficient enough)
high flow exhaust manifold (required to run over 1.2bar boost)
3.0” cat-back high flow exhaustt
Upgraded Engine Mounts
Wideband A/F or lambda display
With the above mods you could easily make 300 whp (~400bhp)
With the addition of the SPS switch it makes modding a lot easier as you do not have to keep having your map tweaked by a custom tuner.
Say for example that you want to use your stock exhaust manifold with the bigger turbo until you buy a high flow manifold, you can keep boost and timing nice and low so that it runs safe.
I made 307bhp on a stock exhaust and manifold. I had my Garrett 71r Eliminator turbo bolted to both of these and still made good power.
ECU is located in Dublin, Ireland. It will be boxed in a secure box and sent under registered post