planning to fit the springs next weekend, just wondering if its pretty much straight forward and any specialist tools needed or not. any advice welcome..also fitting rs4 arb but that looks easy ish..
diy fitting of new lowering springs 19tdi se
- Thread starter stephen lab
- Start date
Dazmo
Registered User
What springs you getting mate and where from?
How much you lowering it by? im thinking of doing this myself but dont want to go lower than 30mm.
You will need spring compressors, a deep swan necked spanner 21mm IIRC and a good solid jack and stands. Over and above standard half inch drive sockets etc
Dazmo
Registered User
Ok graham goode do these pro kits for my car at 30mm for £152, anyone know of anywhere cheaper for these?
http://shop.grahamgoode.com/eibach-...rd-30-tdi-quattro-e10-15-003-03-22-7226-p.asp
http://shop.grahamgoode.com/eibach-...rd-30-tdi-quattro-e10-15-003-03-22-7226-p.asp
im fitting eibach springs 40mm rear 50mm front and i got them from dpm, they advertise on the forum. what part is the swan neck spanner for?
The damper top nuts, they are sunk down quite a bit and you need to be able to get an allen key through the centre to hold the damper piston still.
Dazmo
Registered User
anyone got any pics of a b7 audi a4 on 30mm eibach springs?
Just want an idea of how low they will look?
Just want an idea of how low they will look?
so do you take the rear damper off from the top or bottom, sorry for keep asking but id rather know now, just so it go,s smoothly at the weekend.
ok this is for a B5 but they are similar on the front anyway
http://www.audiworld.com/tech/wheel28.shtml
http://www.audiworld.com/tech/wheel14.shtmlhttp://www.audiworld.com/tech/wheel28.shtml
http://www.audiworld.com/tech/wheel28.shtml
http://www.audiworld.com/tech/wheel14.shtmlhttp://www.audiworld.com/tech/wheel28.shtml
