Exhaust question

[Bradderz_1988]

As i will be getting my hands on a full milltek system at some point this month i want to now the diameter of the standard TQS exhaust system as i need to order some new clamps for the downpipe and the back box ??

i think i asked this question a while ago but i cant seem to find it is it 2.25" ????

 

[aragorn]

stock system is 2.25" or 57mm

If your fitting a milltek system its larger afaik?

 

[PaulJC84]

I am sure I read the miltek is 2.75"

 

[Bradderz_1988]

Ye the milltek is 2.75 but im gunna order some for my system do that when i do the swap there will be all new clamps and gaskets on the car the milltek is coming off.

 

[aragorn]

ah k

The stock system is one piece, so you should only need the clamp at the downpipe unless the backbox has been replaced at some point.

 

[Bradderz_1988]

Theres a clamp at the rear so suspect its been replaced at some point.

 

[aragorn]

best measure it, ETKA says some systems are 55mm and some are 60mm at the joint between boxes...

 

[Bradderz_1988]

I might aswel just order both size clamps and just have parts at work send the wrong one back rather than going under the car !!