back bumber twin pipes sizes pleas

[stevie_g]

Hi


Am going to custom my back bumper save on buying one with the two holes cut for the twin pipes
If I make a balls up then will just have to buy one then.
What am looking for if someone could pleas help need sizes.

The width and diameter of the hole for the teal peace and the distance between the two pipes.

Car is booked in for Fri. to get colure coded

any help will be great
Thanks….

 

[quattrojames]

I've got one outside, I will measure it tomorrow if you can wait until then?

 

[stevie_g]

yea that would be great thanx.

 

[Woorlord]

....... save on buying one with the two holes cut for the twin pipes
If I make a balls up then will just have to buy one then.

Hi "Stevie-g",

Just taken my rear lower valance off to fit an S-line one - Do you want my old one, if you can arrange collection?
Was going to post it on Ebay at the weekend.

There are some scuffs on the n/s just behind the rear wheel - but you can't see them as underneath.

Link to a Hi-res picture.... Picture Here
and Close-ups of Offside and Near side

Let me know.

 

[quattrojames]

@ Woorlord, is that valance from a saloon?

Ok here are the measurements, I hope they make sense, let me know if you need anything else.

 

[Woorlord]

@ Woorlord, is that valance from a saloon?

Yep - Saloon.

Thought Saloon & Avant were the same for the valance - only the upper bumper is model dependent?

 

[quattrojames]

Thought Saloon & Avant were the same for the valance - only the upper bumper is model dependent?

How sure are you about that? The part numbers are different.

 

[Woorlord]

How sure are you about that? The part numbers are different.

Not sure enough! Your right lower valance is model dependent too.
The standard valance is preceded 8E5 for Saloon, 8E9 for Avant.
The valance I have shown is marked 8E5 807 512 A and I should have 7DL added for "grey colour"

Thanks for clarifying that small detail

 

[stevie_g]

Hi "Stevie-g",

Just taken my rear lower valance off to fit an S-line one - Do you want my old one, if you can arrange collection?
Was going to post it on Ebay at the weekend.

There are some scuffs on the n/s just behind the rear wheel - but you can't see them as underneath.

Link to a Hi-res picture.... Picture Here
and Close-ups of Offside and Near side

Let me know.

no thanks lad am from n .ireland be a bit out of the way to go a we drive to pick it up lol.
going to cut the back bumper see how it looks.

thanks agan

 

[stevie_g]

@ Woorlord, is that valance from a saloon?

Ok here are the measurements, I hope they make sense, let me know if you need anything else.

thanks very much thats everything i need..

 

[quattrojames]

No problem Stevie. Personally I think that if you cut you will weaken the structure of it and it may lose it's shape and stuff. The standard grey lowers seem cheap enough on ebay (for saloons anyway lol).

Not sure enough! Your right lower valance is model dependent too.
The standard valance is preceded 8E5 for Saloon, 8E9 for Avant.
The valance I have shown is marked 8E5 807 512 A and I should have 7DL added for "grey colour"

Thanks for clarifying that small detail

No worries, I am quite knowledgable in this from my extensive searching lol!