Hi guys,
I am looking at fitting an OEM set up of PDC to an A3. Not the Audi off the shelf kit.
I see all the looms can be bought from Kufatec, which leaves me with a few questions:
1. Can you use your normal non PDC rear bumper and simply hole saw the holes, and glue the PDC brackets to the rear of th bumper. This allowing the OEM flush sensor mounted look.
2. Where is the OEM position for the control module and the buzzer?
3. Where does the loom from the control module connect when it heads to the front of the car? DOes it plug into available spaces in an empty connector up front?
Any help would be great! Thanks!
Terry
I am looking at fitting an OEM set up of PDC to an A3. Not the Audi off the shelf kit.
I see all the looms can be bought from Kufatec, which leaves me with a few questions:
1. Can you use your normal non PDC rear bumper and simply hole saw the holes, and glue the PDC brackets to the rear of th bumper. This allowing the OEM flush sensor mounted look.
2. Where is the OEM position for the control module and the buzzer?
3. Where does the loom from the control module connect when it heads to the front of the car? DOes it plug into available spaces in an empty connector up front?
Any help would be great! Thanks!
Terry