Hi all, new to the forum. Been lingering on here for a while, and now in need of some advice. purchased a 2007 audi s3 53k few weeks ago and engine seemed to be running sweet until it was booked in for an MOT + detail.
Anyway long story short last week the left engine mounting snapped away from the engine with no warning, causing the block to crack and yanking the bolts out of place. the coolant all leaked out however the engine would still run very rough.
It is now in need of a new block then popping old engine out and swapping bits over. The main issue is finding a BHZ engine block. I have been advised that i can pop the a GTI engine block in and it should be a straight fit. Are there any issues with this i.e. the pistons/rods different etc? I have done a little research but brought back many contradicting results.
Any two pence worth would be appreciated, any information on where i can source a block and any idea on how much this years holiday piggie bank will be short!
Other than that was great the 50 miles it was driven . Many thanks
Anyway long story short last week the left engine mounting snapped away from the engine with no warning, causing the block to crack and yanking the bolts out of place. the coolant all leaked out however the engine would still run very rough.
It is now in need of a new block then popping old engine out and swapping bits over. The main issue is finding a BHZ engine block. I have been advised that i can pop the a GTI engine block in and it should be a straight fit. Are there any issues with this i.e. the pistons/rods different etc? I have done a little research but brought back many contradicting results.
Any two pence worth would be appreciated, any information on where i can source a block and any idea on how much this years holiday piggie bank will be short!
Other than that was great the 50 miles it was driven . Many thanks