Intercooler pipes?

[nicklght]

Hey everyone i recently purchased this intercooler

But im having trouble finding the pipes to fit it, has anyone got any ideas on where i could get them made or purchase them?

The size of the intercooler is 600x300x76mm with an inlet size of 3"

What about this? http://cgi.ebay.co.uk/3-TURBO-INTER...ryZ72205QQssPageNameZWDVWQQrdZ1QQcmdZViewItem

Cheers everyone

 

[sitrials]

that pipe kit would work but you would have to flange the ends of the pipe to stop the hoses blowing off i am also considering going down this route.
how much did the cooler cost just out of interest??

 

[nicklght]

The intercooler was only £90 and its a pretty good 1.

Sorry not very good with stuff like that, What does flange the ends mean? lol

I got it from ebay heres the link

http://cgi.ebay.co.uk/Big-Large-Uni...ZWD1VQQ_trksidZp1638.m118.l1247QQcmdZViewItem

 

[sitrials]

you would have to get 2 pairs of mole grips and spread the end of the pipes out so it gives the jubilee clips something to bite onto!
i think the 3'' inlet might be a bit big and the intercooler might be too big and create alot more lag! let us know how it goes though!

 

[Dave_Bayern]

I have a couple pipes I shortened and thus lost the flange. Using Mikalor clamps instead of jubilee and there are no leaks whatsoever. I have been pushing 20+ psi through them too so i doubt a K04 would get near that kind of pressure.

Dont worry about the lack of flanges.