dgannon69
Registered User
hi guys, had my bysparf or however you pronounce it (geometry set up) done at audi 2 months ago and just looking back through the print out i got from them it shows they couldnt get the front axel castor 20(degrees) back into the tollerance zone of -0*30 [7*50] +0*30
it ended up been something like left 7*17
right 7*14
basically is there something i can replace to correct this or does it not make a difference if it's a nats **** out or not?
Cheers
Dave
it ended up been something like left 7*17
right 7*14
basically is there something i can replace to correct this or does it not make a difference if it's a nats **** out or not?
Cheers
Dave