Hi im planning on rebuilding my engine in the new year i have a 1999 Audi S3 APY, I want to replace the following parts......
Rods (rifle drilled)
Rod Bearings
PistonRings
Cambelt kit & Water pump
Head Gasket kit
Head looked at..
Head Bolts
Oil pump
Oil pickup
Obvious gaskets (that are needed)
BBT Hybrid k04
New Exhaust Mani (hopefully Badger one)
550cc Injectors
Relentless 3inch DP
WMI (of some sort)
Now my main question is I have a AYP bottom end which has had new bearings and piston rings fitted, It was started and run for around 2 miles.
Would the bearings and Piston rings out of the AYP engine fit my current APY engine as there basically brand new.
Or am i being stupid and should just buy new again????
Thanks
Rods (rifle drilled)
Rod Bearings
PistonRings
Cambelt kit & Water pump
Head Gasket kit
Head looked at..
Head Bolts
Oil pump
Oil pickup
Obvious gaskets (that are needed)
BBT Hybrid k04
New Exhaust Mani (hopefully Badger one)
550cc Injectors
Relentless 3inch DP
WMI (of some sort)
Now my main question is I have a AYP bottom end which has had new bearings and piston rings fitted, It was started and run for around 2 miles.
Would the bearings and Piston rings out of the AYP engine fit my current APY engine as there basically brand new.
Or am i being stupid and should just buy new again????
Thanks