Bore finish after re bore

[hoffmanvp3]

Does any one who has Elsawin know what finish the bore needs to be after a re bore?
The finish should have a number, ie type 32 finish,usally has a tranangle symbol after the number.
Obviously i will be honing the bore after machining but need the get the right machining perfections in the bore before hand.

Cheers

 

[<tuffty/>]

Honing specs are normally on the piston specs assuming you are going for aftermarket pistons... they were on my CP pistons...

<tuffty/>

 

[hoffmanvp3]

Cheers Tuffty but i`m after the oem spec of the block, i don't have Elsawin but i`m assuming the bore finish spec should be in the technical data? Like Service limit.
Cheers

 

[<tuffty/>]

Had a quick look but elsa is a bit vague... maybe more data there if I dug about but not had time at the moment...



..and as an example... mine from my CP pistons..



<tuffty/>

 

[hoffmanvp3]

Cheers dude for finding that.
basically it tells the machinist what cutting speed is required, Bit spec e.t.c
i would imagine the smoothest finish available, ie type 32 finish but then again your gonna hone it afterwards so that`ll ruin the type 32 finish anyway.